Applications/Models

     The Battery Life Saver electronic device is suited to all types of lead acid batteries - Flooded, Gel, and AGM. It can be used on individual batteries and banks of all sizes. It is reverse polarity protected - if it is hooked up in reverse, it will draw current but will not damage the battery or itself. The case is isolated. It is used in parallel with a charging source. Each unit is approximately 4.5 inches wide by 2.25 inches deep by 2 inches high and weighs 11.4 ounces. The electronics are potted in an anodized aluminum heat sink, protecting them from the environment.

BLS-36A

     For use with 36 volt battery powered vehicles. Can be mounted on the vehicle to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 3/8 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 12 volts to 45 volts.

BLS-48A

     Ideal for 48 volt renewable energy battery banks or use with battery powered vehicles. Ideally mounted full time to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 3/8 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 24 volts to 65 volts. NOTICE: Use the BLS-48-B for Club Car 48 volt golf carts.

BLS-48B

     Especially designed for Club Car and Yamaha 48 volt models with on board computers. Ideally mounted full time to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 3/8 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 45 volts to 65 volts.

BLS-72A

     For 72 Volt NEV's like the Gem car by Chrysler and Think by Ford. Ideally mounted full time to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 3/8 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 65 volts to 85 volts.

BLS-24/36 Multivolt

     It is similar to the 12/24-B except it works for 24 and 36 volt battery systems. Ideally mounted full time to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 3/8 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 24 volts to 65 volts.

BLS-24/36/48 Multi-Volt

     For forklift batteries. The Battery Life Saver electronic device is enclosed in an insulated housing to prevent shorting on top of the battery Mounted full time to constantly keep the batteries in optimum condition or can be used in conjunction with a battery charger. Comes with 1/4 lugs for attachment to the battery terminals. Maximum current draw 0.5 amps; average 0.25 amps. Voltage window: 24 volts to 65 volts. Installed with #10 self tapping screws drilled into the battery terminals.

BLS-12A

     For use on 12 volt systems. Ideal for 12 volt vehicle battery systems. Runs constantly to keep the battery in optimum condition. Can also be used for battery storage in conjunction with a float charger. Comes with eye rings for attachment to the battery clamp bolts. Maximum current draw 0.1 amp; average 0.06 amps. ONLY FOR USE ON A MOTOR VEHICLE

BLS-12/24B

This is our most popular model. Ideal for 12 and 24 volt renewable energy battery banks. Also ideal for use with a battery charger to rejuvenate unusable batteries (will work even if battery is at 4 volts). Comes with alligator type battery clips. Maximum current draw 0.25 amps at 12 volt and 0.5 amps at 24 volts; average 0.125 amps and 0.25 amps at 12 and 24 volts, respectively. Voltage window: 4 volts to 35 volts. This is the only The Battery Life Saver electronic device designed to recover totally dead batteries.

BLS-12/24C

For use on heavy trucks and other vehicles with multiple batteries up to 4 batteries. Runs constantly to keep batteries in optimum condition. Comes with 5/16 lugs for attachment to the battery clamp bolts. Maximum current draw 0.5 amps; average 0.25 amps. ONLY FOR USE ON A MOTOR VEHICLE.